Benelli Imperiale 400 - Owner's Manual > Driving tips
HOW TO START THE ENGINE
Insert the ignition key into the ignition lock and to "". Step on the shift pedal to the neutral. The neutral indicator light lightens up if the gear box is in neutral position. Start the engine by pushing the start switch.
Caution:
Do not run the engine in high speed when you do not drive the motorcycle, or it will become overheating and damage its inner parts.
Warning:
Do not start the engine indoor with bad ventilation or without ventilation. Do not leave a starting motorcycle when no one else is around.
SMOOTH LAUNCHING
Hold the clutch lever, paused for an instant and step on the shift pedal to the first gear. Twist the throttle grip towards yourself and release the clutch lever slowly and smoothly at the same time. Then the motorcycle will begin to move forward smoothly.
Warning:
Put the stands back to retracted position before driving.
Gear box usage
Gear box can ensure a smooth running of engine within normal engine rpm Driver should choose a proper gear according to driving speed. It is dangerous to drive with clutch disengaged. Lower the gear when you slow down the motorcycle to make engine run within normal rpm range.
Drive on slope way
When drive on uphill road, motorcycle will slow down and seem to be lack of power. Switch to low gears so that engine can generate normal power. Shift the gear swiftly to prevent motorcycle from losing speed.
Turn to low speed gears in order to brake when driving on downhill slope.
Don't over rev the engine.
Brake usage and stopping
Twist the throttle grip in the direction away from yourself to close the throttle. Use front and rear brake evenly.
Shift to low speed gear to slow down.
Before stopping the motorcycle, hold the clutch and shift to neutral position. Check the neutral position indicator light to check whether it is in neutral position.
Notice:
Inexperienced drivers usually use rear brake only, which will accelerate abrasion of the brake and result in longer stopping distance.
Warning:
It is dangerous only to use either the front brake or rear brake which may causes the motorcycle to skid or lose control. Be careful and use brakes properly when you drive on wet road or curved road.
The motorcycle should be parked on firm and at road. If you have to park the motorcycle on a slope by the side stand, please shift to the first gear to prevent slipping. Shift to neutral position before starting the engine.
Turn the power key to the position "" to stop the engine.
Remove ignition key from the switch after locking for security reason.
See also:
Benelli Imperiale 400 - Owner's Manual > Running In
For driving a new motorcycle in its first 1,000 km way, the engine should not be over revved and all the gears shall not be over 80% of red zone engine rpm; don't operate the throttle under a fully open position; change the gears in time to keep the engine rpm in reasonable range. It is strongly suggested to use the motorcycle very carefully during its running in period; also the rider has to be familiar to the performance.